Unlock Your Datasette

[cbmx]

merhaba
bu resimdeki bord resmini netten buldum. Bendeki bordun aynısı, yükle işlemini başarılı bir şekilde yaptım, fakat kasede kayıt yapmak için hangi pinlere lehim yapmam gerekiyor bulamadım.

[Remzi]

Merhaba,hosgeldiniz.
Elimde bu board'dan var.Pazar gunu kasete kayit yapmayi deneyip sonuclari burada paylasirim.

[cbmx]

hoşbuldum
teşekkür ederim

[Remzi]

Direnc veya kondansator kullanmadan,direk isaretli pinlere baglanti yapabilirsin.

Buradaki oyunlardan Commando'yu kaydedip denedim,sorunsuz calisti.

Kayit yaparken sesini sonuna kadar ac.Kasetten C64'e yuklerken,kayit yaparken kullandigin ses kaynagini kapatmayi unutma.

[cbmx]

hemen deneyeceğim, bilgi için teşekkürler 

[Wakd21]

I have a Mode 1530 board and I cannot see where to solder the wire for ground and left.

[Remzi]

I marked the LEFT and GND on the photo below.
You need to use a 100nf capacitor or a 100K resistor.

>

[backtogeek]

Thanks from the future

I was looking for a similar board to mine after finding another guide and found this one, is a 100kohm resistor required on the left for this as other guides have suggested?

[backtogeek]

actually, I re-read everything and found more info in this post too.

I did not have any ceramic caps so I put a 0.1uF electrolytic capacitor on instead, positive side soldered to the board.

This time it came up saying "found file"

However it did not ultimately load even the intro screen, i will experiment a bit further and update for other future people.

[backtogeek]

Ok all working:




Little youtube video pre-cable tidy:

I hope that perhaps helps someone in the future.

[Remzi]

That's a grand job mate 
Thanks for posting your results.

[backtogeek]

That's a grand job mate 
Thanks for posting your results.

Thanks, I don't suppose you are aware of anything like tapdancer or CDT2WAV (Amstrad cpc464 equivalent mod) that runs on PC/Windows (or linux) ?

It would save a lot of effort and steps if I did not need to convert every single game to wav first.

[backtogeek]

I just got another old one out of my junk box, the heads are gone on this one, it shows absolutely nothing when running any tape head alignment so I might as well do the same to this one as it will never read tapes again.

I cant seem to identify the left on it though, any ideas?

[backtogeek]

Sorry for the bump, anyone got any ideas on the board above before I buy an oscilloscope

[Remzi]

I need to check my tape decks to find one with the same board.